• Removed all components from the base
• Sandblast, prime and paint base casting (Using high quality Polyurethane paint)
• Replace all floor lock post, feet and brass linkages (very important for proper operation)
• Replace both the control and motor batteries
• Replace the power entry module
• Replace all base Molex plugs including the electrical pins (Very important for a long-lasting power supply)
• Replace the all 4 caster/wheel assemblies with New
• Replace the floor lock micro-switches
• Replace power cord (20′ molded hospital grade)
• Polish stainless base cover to look like new

Column

• Remove entire column from table and disassemble, polish, and lubricate to prevent future rust
• Replace the slide bearings and column oilers with new (Very important for smooth operation)
• Replace the upper bushings (Very, very important to prevent table movement/play)
• Rebuild the main lift hydraulic cylinder
• Inspect all hydraulic fittings, solenoids and wire connections
• Replace column plastic shrouds with new
• Polish all shrouds to look like new

Tabletop

• Remove all side rails
• Remove leg sections
• Sand, Prime and Paint (Using high quality Polyurethane paint)
• Replace the leg section bearings (Very important for smoothness)
• Remove headboard and sand prime and paint
• Replace hand control housing, Hanger and coil cord
• Replace Velcro for pad-set
• Polish all side rails and spacers to look like new
• Check all hydraulic cylinders and fittings
• Check Kidney assembly gears
• Confirm the Return to level is calibrated

Completion

• Attach the base, column and top.
• Secure all fasteners using the appropriate thread lock
• Check all wire connections and secure
• Affix all new decals
• Perform an electrical safety test (Very important for bio-med)
• Install new 3″ Memory foam pad set
• Send through our quality control department